I. Scope of application: this product is applicable to outdoor lighting for flood fighting, sudden repair and night engineering; electric power, firefighting, railway, military and other industries.
II. Product features:
1. According to the needs of on-site work, the lamp cap can realize 360° omni-directional lighting with high brightness and long light source life.
2. 4 sections of telescopic cylinders are used to adjust the lifting height of the lamp panel with electric or manual control mode available and the maximum lifting height is about 4.5m.
3. Through the wireless remote control, all lamps within 30m can be separately controlled to be turned on and off.
4. The panel, cylinder and generator set form an overall structure, and universal wheels and rail wheels are mounted at the generator bottom, making it possible to run on roads and rails.
5. The light is made o high-quality metal materials, compact, stable, and capable of ensuring normal operation under all kinds of harsh environments to prevent rain and water spraying. The wind resisting level is 8.
III. Use methods:
1. Place the generator on a relatively flat ground and press the buckle on the universal wheel to ensure it does not roll; lift the telescopic cylinder upwards with the cylinder holder pin shaft as the fulcrum, so that it can be erected perpendicular to the ground, pull up the hand-pull pin bolt at the bottom of the telescopic cylinder and lock it into the fixing pin groove of the cylinder, and tighten the lock screw on the other side to fix the cylinder; tighten the hand-screw bolt at the bottom of the lamp panel to fix the lamp base.
2. Please follow the instructions from the original factory to operate the generator.
3. Plug the power plug of the lamp and power plug of the air pump into the power board on the generator support after the generator is started, and press corresponding switches on the power board to make the lamp and the cylinder work.
4. Operate according to the configured remote control to realize turn-on and turn-off of a single lamp cap.
5. Turn on the power switch on the air pump, and the air pump starts working and rises automatically; turn off the air pump power switch immediately after the pump stops at the highest position; press the air release valve at the bottom of the cylinder and the cylinder will slowly descend. Pull out the self-locking device under the cylinder base and open the fastening insurance to lay down the cylinder which then shall be tightly fastened with a ribbon.
6. Loosen the two manual bolts on the lamp base and adjust the lamp panel by 90 degrees so that the 4 lamp caps can illuminate in the same direction. The lighting direction of each lamp cap can also be flexibly adjusted according to the needs of the work site.
7. turn off the generator set after use. If it is necessary to disassemble the lamp and box it, simply unscrew the manual bolts at the bottom of the cylinder clamp and separate the cylinder from the generator bracket, remove the lamp panel, and pull out the aviation plug.
1. Protection grade: IP65;
2. Corrosion-proof level: WF2;
3. Power: 4×500/1000W;
4. Power of generator: 5000W;
5. Wind resistance level: 8;
6. Lifting height: 1.8-4.5m.
12 months from the date of delivery